
Precaution Information
Version 1.5 6
1 Precaution
RISK OF ELECTRIC SHOCK
Use this unit only with the correct voltage as shown on the type
label.
Do not expose the unit to extreme heat or moisture.
Do not expose the unit to water, metallic objects or any flamma-
ble material.
Make sure that sufficient air circulation for cooling the unit is
possible!
Do not use a damaged power cord / power supply. This may
cause short circuits or electrical shocks!
To prevent danger, do not modify the unit or operate it without a
case.
Never use the unit without case.
Never touch the power supply or power cord with wet fingers.
If the unit is not used for a long time, disconnect it from mains!
The power source equipment has to be approved by CSA or UL
in accordance to CSA 22.2-60950 or UL 1950. And it shall
comply with all applicable local and national codes related to
safety.
The Power over Ethernet power equipment (PoE PSE) shall be
classified as Limited Power Source (LPS) in accordance with
IEC 60950-1:2001.
RISK OF HURTING YOUR EYES
Do not stare into laser beam of the remote control.
Laser class II
Wavelength 650 nm
The laser is conform to EN 60825-1 March 1997.
The laser beam exits the remote control through the smaller (left)
opening on the front.
RISK OF DAMAGING THE UNIT
Protect the unit from excessive shocks.
Do not expose the unit to extreme heat or moisture.
Do not expose the unit to water, metallic objects or any flamma-
ble material.
Make sure that sufficient air circulation for cooling the unit is
possible!
If there is any abnormality (abnormal noise, smell, smoke etc.)
disconnect the unit from mains immediately and contact your
WolfVision dealer!
Avoid installing the unit in environments where there is radiation.
Avoid installing the unit in locations exposed to strong magnetic
fields or electrical currents. This could cause monitor image
distortion or damage to the CCD camera.
Never use strong cleaning agents!
Comentários a estes Manuais