WolfVision VZ-8plus Manual do Utilizador descarregar pdf (Página 3)

Zoom Control

Page Dec.

Code

Hex.

Code

Command Description see

Notes

0 195 $C3 Zoom wide By sending this command the Visualizer zooms

towards wide-position. For continuous zooming,

send this code repetitively (min. 10Hz) as long as

you want to zoom.

0 199 $C7 Zoom tele By sending this command the Visualizer zooms

towards tele-position. For continuous zooming,

send this code repetitively (min. 10Hz) as long as

you want to zoom.

0 129 $81 Start Zoom wide This command starts to zoom towards the wide-

position. The Visualizer zooms until the „Stop

Zoom/Focus/Iris“-command or a different Start-

Command is received (or the mechanical end-

position is reached).

0 130 $82 Start Zoom tele This command starts to zoom towards the tele-

position. The Visualizer zooms until the „Stop

Zoom/Focus/Iris“-command or a different Start-

Command is received (or the mechanical end-

position is reached).

0 128 $80 Stop

Zoom/Focus/Iris

This command stops zooming, focusing and iris

(if activated with the respective „Start xxx“-

command before).

0 161 $A1 Get Zoom-Position After sending this command the Visualizer sends

back the current zoom-position as a 3-digit

hexadecimal number in the range from ‘000’

(wide) to ‘FFF’ (tele) as an ASCII-string followed

by LF and CR.

2, 3

0 162 $A2 Set Zoom-Position After this command the Visualizer echoes a

question-mark (‘?’) with no LF and CR. After this

question mark the controller should send the

wished zoom-position as 3-digit hexadecimal

number in the range from ‘000’ (wide) to

‘FFF’(tele) within max. 3 seconds. No CR or LF is

needed. After receiving the 3rd digit the Visualizer

zooms to this position.

2, 3

1 163 $A3 Set Digital Zoom After this command the Visualizer echoes a

question-mark (‘?’) with no LF and CR. After this

question mark the controller should send the

wished digital zoom-position as 3-digit

hexadecimal number in the range from ‘000’

(wide) to ‘FFF’(tele) within max. 3 seconds. No

CR or LF is needed. After receiving the 3rd digit

the Visualizer zooms to this position.

1 164 $A4 Get Digital Zoom After sending this command the Visualizer sends

back the current digital zoom-position as a 3-digit

hexadecimal number in the range from ‘000’

(wide) to ‘FFF’ (tele) as an ASCII-string followed

by LF and CR.

T-01-04.RS232 Protocol VZ-8_plus_light.doc Page 3

1 2 3 4 5 6 7 8 ... 17 18

Comentários a estes Manuais

Sem comentários

WolfVision VZ-8plus Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Máquinas fotográficas p/ cópia de documentos WolfVision VZ-8plus