WolfVision VZ-8plus Manual do Utilizador descarregar pdf (Página 4)

Focus Control

Page Dec.

Code

Hex.

Code

Command Description see

Notes

0 194 $C2 Focus far By sending this command the Visualizer focuses

towards far. For continuous changing the focus,

send this code repetitively (min. 10Hz) as long as

you want to change the focus.

0 198 $C6 Focus near By sending this command the Visualizer focuses

towards near. For continuous changing the focus,

send this code repetitively (min. 10Hz) as long as

you want to change the focus.

0 131 $83 Start Focus far This command starts to focus towards far. The

Visualizer changes the focus until the „Stop

Zoom/Focus/Iris“-command or a different

Start-Command is received (or the mechanical

end-position is reached).

0 132 $84 Start Focus near This command starts to focus towards near. The

Visualizer changes the focus until the „Stop

Zoom/Focus/Iris“-command or a different

Start-Command is received (or the mechanical

end-position is reached).

0 128 $80 Stop

Zoom/Focus/Iris

This command stops zooming, focusing and iris

(if activated with the respective „Start xxx“-

command before).

0 163 $A3 Get Focus-

Position

After sending this command the Visualizer sends

back the current focus-position as a 3-digit

hexadecimal number in the range from ‘000’

(near) to ‘FFF’ (far) as an ASCII-string followed by

LF and CR.

2, 3

0 164 $A4 Set Focus-

Position

After this command the Visualizer echoes a

question-mark (‘?’) with no LF and CR. After this

question mark the controller should send the

wished focus-position as 3-digit hexadecimal

number in the range from ‘000’ (near) to ‘FFF’(far)

within max. 3 seconds. No CR or LF is needed.

After receiving the 3rd digit the Visualizer moves

to this position.

2, 3

0 239 $EF AF-ON Switches the Auto Focus on.

0 240 $F0 AF-OFF Switches the Auto Focus off.

0 173 $AD Get Auto Focus This function returns ‘1’ +LF+CR if the AF is

switched on and ‘0’ if the AF is switched off.

T-01-04.RS232 Protocol VZ-8_plus_light.doc Page 4

1 2 3 4 5 6 7 8 9 ... 17 18

Comentários a estes Manuais

Sem comentários

WolfVision VZ-8plus Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Máquinas fotográficas p/ cópia de documentos WolfVision VZ-8plus