WolfVision VZ-8plus Manual do Utilizador descarregar pdf (Página 5)

Iris Control

Page Dec.

Code

Hex.

Code

Command Description see

Notes

0 193 $C1 Iris open /

Brightness up

By sending this command the Visualizer opens

the iris. For continuous opening the iris, send this

code repetitively (min. 10Hz) as long as you want

to open iris.

0 197 $C5 Iris close /

Brightness down

By sending this command the Visualizer closes

the iris. For continuous closing the iris, send this

code repetitively (min. 10Hz) as long as you want

to close iris.

0 133 $85 Start Iris open This command starts to open the iris. The

Visualizer opens the iris until the „Stop

Zoom/Focus/Iris“-command or a different Start-

Command is received (or the mechanical end-

position is reached).

0 134 $86 Start Iris close This command starts to close the iris. The

Visualizer closes the iris until the „Stop

Zoom/Focus/Iris“-command or a different Start-

Command is received (or the mechanical end-

position is reached).

0 128 $80 Stop

Zoom/Focus/Iris

This command stops zooming, focusing and iris

(if activated with the respective „Start xxx“-

command before).

0 167 $A7 Auto Iris on Switches the Auto Iris on.

0 168 $A8 Auto Iris off Switches the Auto Iris off.

0 166 $A6 Get Auto Iris This function returns ‘1’+LF+CR if the Auto Iris is

switched on and ‘0’+LF+CR if the Auto Iris is

switched off.

0 165 $A5 Get Iris-Position After sending this command the Visualizer sends

back the current iris-position as a 3-digit

hexadecimal number in the range from ‘000’

(close) to ‘FFF’ (open) as an ASCII-string

followed by LF and CR.

2, 3

0 169 $A9 Set Iris-Position After this command the Visualizer echoes a

question-mark (‘?’) with no LF and CR. After this

question mark the controller should send the

wished iris-position as 3-digit hexadecimal

number in the range from ‘000’ (close) to

‘FFF’(open) within max. 3 seconds. No CR or LF

is needed. After receiving the 3rd digit the

Visualizer moves to this position.

2, 3, 4

T-01-04.RS232 Protocol VZ-8_plus_light.doc Page 5

1 2 3 4 5 6 7 8 9 10 ... 17 18

Comentários a estes Manuais

Sem comentários

WolfVision VZ-8plus Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Máquinas fotográficas p/ cópia de documentos WolfVision VZ-8plus